PH13-8Mo Stainless Steel
VerifiedmetalPH13-8Mo is a precipitation-hardening martensitic stainless steel (13% Cr, 8% Ni, Mo) used in aerospace and high-performance applications requiring high strength (yield strength typically 1,240–1,520 MPa depending on temper) and good corrosion resistance up to ~300°C. The H-series tempers (H950–H1150) provide increasing strength levels through controlled aging, with H1050 being the most common aerospace specification balancing strength and fracture toughness.
aerospacestructural
Compliance & Regulations
?Conflict Free?RoHS?REACH?TSCA?Prop 65
Filter by
Form
| Property | Value | Unit | Conditions | Source | |
|---|---|---|---|---|---|
Compressive Modulus(Ec)2 entries | — | ksi | 22°C · Round, hex, square and flat bar | — | |
| ↳ | — | ksi | 22°C · Extrusion/Forging | — | |
Poisson's Ratio(ν) | — | - | 22°C | — | |
Shear Modulus(G) | — | ksi | 22°C · Extrusion/Forging | — | |
Young's Modulus(E)2 entries | — | ksi | 22°C · Round, hex, square and flat bar | — | |
| ↳ | — | ksi | 22°C · Extrusion/Forging | — |
N entriesMultiple entries per property — large groups are collapsed; click a summary row to expand. Use filters above to narrow by form / heat treatment / basis.
Verified Unverified Low confidence (<80%) Link to source
| Property | Value | Unit | Conditions | Source | |
|---|---|---|---|---|---|
CTE vs Temperature(α(T)) | Curve (15 pts) | µin/in·°F | — | — | |
Thermal Conductivity vs Temperature(k(T)) | Curve (16 pts) | BTU/(hr·ft·°F) | — | — |
Verified Unverified Low confidence (<80%) Link to source
| Property | Value | Unit | Conditions | Source | |
|---|---|---|---|---|---|
Density(ρ) | — | lb/in³ | 22°C | — |
Verified Unverified Low confidence (<80%) Link to source
Regulatory Screening
Environmental
Quality & Standards
Industry-Specific
RoHS, REACH, and Prop 65 statuses are validated against official substance lists (ECHA SVHC Candidate List, OEHHA Prop 65, RoHS Annex II). Other regulations are estimated from composition and material classification. All screening is a starting point for due diligence — always verify with your supplier before making compliance decisions.