MMC SiC/Al 6061 (20% SiCp)
Verifiedcomposite· SiC/Al MMC· Aluminum MMC· DurAlBB®
SiC/Al 6061 is a metal matrix composite (MMC) consisting of silicon carbide particles (20 vol%) dispersed throughout an aluminum 6061-T6 matrix, typically produced via stir casting or powder metallurgy. This material combines the lightweight and workability of aluminum with the stiffness and hardness of ceramic particles, offering improved strength-to-weight ratio and wear resistance compared to unreinforced aluminum alloys. It is used in automotive and aerospace applications where weight reduction, thermal management, and structural rigidity are critical, and represents a practical middle ground between conventional aluminum alloys and more expensive fiber-reinforced composites.
automotive engine componentsaerospace brake rotorsthermal management housingswear-resistant bearings and bushingshigh-performance pistons
Compliance & Regulations
?Conflict Free?FDA?RoHS?REACH?TSCA?Prop 65
| Property | Value | Unit | Conditions | Source | |
|---|---|---|---|---|---|
Hardness (Vickers)(HV) | — | HV | — | — | |
Ultimate Tensile Strength(σUTS) | — | ksi | — | — | |
Young's Modulus(E) | — | ksi | — | — |
Verified Unverified Low confidence (<80%) Link to source
| Property | Value | Unit | Conditions | Source | |
|---|---|---|---|---|---|
Thermal Conductivity(k) | — | BTU/(hr·ft·°F) | — | — | |
Coefficient of Thermal Expansion(α (CTE)) | — | µin/in·°F | — | — |
Verified Unverified Low confidence (<80%) Link to source
| Property | Value | Unit | Conditions | Source | |
|---|---|---|---|---|---|
Density(ρ) | — | lb/in³ | — | — |
Verified Unverified Low confidence (<80%) Link to source
Regulatory Screening
Environmental
Safety & Biocompatibility
Quality & Standards
Industry-Specific
RoHS, REACH, and Prop 65 statuses are validated against official substance lists (ECHA SVHC Candidate List, OEHHA Prop 65, RoHS Annex II). Other regulations are estimated from composition and material classification. All screening is a starting point for due diligence — always verify with your supplier before making compliance decisions.