Ti-6Al-4V ELI (Grade 23) (L-PBF, 3D Systems LaserForm Ti Gr23 (A), HIP) — Properties & Data | MatWorld

Ti-6Al-4V ELI (Grade 23) (L-PBF, 3D Systems LaserForm Ti Gr23 (A), HIP)

UNS R56407· LaserForm Ti Gr23 (A)

3D Systems LaserForm Ti Gr23 (A) is that maker's Ti-6Al-4V ELI (Grade 23) grade for laser powder bed fusion, here in the hot isostatically pressed condition. As printed, rapid cooling gives fine alpha-prime martensite in columnar prior-beta grains along the build direction, with residual stress, support structures and a rough surface. HIP closes internal porosity and decomposes the martensite into a coarser lamellar alpha-beta structure. This improves ductility and fatigue resistance and reduces anisotropy, though surfaces still need machining or finishing where fatigue matters. Typical parts are orthopedic implants, porous lattice structures and lightweight aerospace components. Every value on this page is read from 3D Systems' own material data sheet — quoted, cited and dated — and is the maker's statement about printed material, not a measurement by MatWorld; none has yet been reviewed by a person.

orthopedic implantsporous lattice structureslightweight aerospace components

Compliance & Regulations

?UL 94?ITAR?EAR?ISO 10993?Conflict Free?FDA?RoHS?REACH

Ti-6Al-4V ELI (Grade 23, L-PBF)/Ti-6Al-4V ELI (Grade 23) (L-PBF, 3D Systems LaserForm Ti Gr23 (A), HIP)

Units:

si imperial

Property OverviewNormalized to typical max values

Filter by

Table

Orientation

Specification

Property	Value	Unit	Conditions
Elongation at Break(εf)	10.00 – 22.00	%	6 entriesClick to expand
Reduction of Area(RA)	30.00 – 55.00	%	6 entriesClick to expand
Ultimate Tensile Strength(σUTS)	0.9350 – 1.080	GPa	6 entriesClick to expand
Yield Strength (0.2% offset)(σy)	815.0 – 990.0	MPa	6 entriesClick to expand

N entriesMultiple entries per property — large groups are collapsed; click a summary row to expand. Use filters above to narrow by form, heat treatment, basis, or test environment.

Verified Unverified Low confidence (<80%) Link to source

Property	Value	Unit	Conditions	Source
Density(ρ)	4.430	kg/m³	—	—

Rows with are inherited from the base material

Verified Unverified Low confidence (<80%) Link to source

Reference data from cited sources. Not verified or certified by MatWorld Inc. Verify against the source before use in design. Terms: engineering data

Regulatory Screening

Environmental

Export Control

Safety & Biocompatibility

Quality & Standards

Industry-Specific

RoHS, REACH, and Prop 65 statuses are validated against official substance lists (ECHA SVHC Candidate List, OEHHA Prop 65, RoHS Annex II). Other regulations are estimated from composition and material classification. All screening is a starting point for due diligence — always verify with your supplier before making compliance decisions.