Inconel 718 (L-PBF, Velo3D Inconel 718, HIP) — Properties & Data | MatWorld

Inconel 718 (L-PBF, Velo3D Inconel 718, HIP)

UNS N07718· Inconel 718

Velo3D Inconel 718 (HIP) is Velo3D's grade of the nickel superalloy Inconel 718, printed by laser powder bed fusion and then hot isostatically pressed. As printed, the alloy has fine columnar grains along the build direction, niobium-rich segregation with Laves phase between dendrites, residual stress and some internal porosity. Hot isostatic pressing closes internal pores, dissolves much of the segregation and partly recrystallizes the grains, which reduces anisotropy and improves fatigue life. Solution treatment and aging are still needed for full strength, and critical surfaces are machined. Typical parts are gas turbine and rocket engine hardware such as manifolds, injectors, combustor components and brackets. Every value on this page is read from Velo3D's own material data sheet — quoted, cited and dated — and is the maker's statement about printed material, not a measurement by MatWorld; none has yet been reviewed by a person.

gas turbine hardwarerocket engine hardwaremanifoldsinjectorscombustor componentsbrackets

Compliance & Regulations

?UL 94?ITAR?EAR?ISO 10993?Conflict Free?FDA?RoHS?REACH

Inconel 718 (L-PBF)/Inconel 718 (L-PBF, Velo3D Inconel 718, HIP)

Units:

si imperial

Property OverviewNormalized to typical max values

Filter by

Statistic

Table

Temperature

Orientation

Property	Value	Unit	Conditions
Elongation at Break(εf)	11.30 – 24.20	%	22 entriesClick to expand
Ultimate Tensile Strength(σUTS)	1.020 – 1.350	GPa	22 entriesClick to expand
Yield Strength (0.2% offset)(σy)	0.8070 – 1.103	GPa	22 entriesClick to expand
Young's Modulus(E)	131.0 – 207.0	GPa	6 entriesClick to expand

N entriesMultiple entries per property — large groups are collapsed; click a summary row to expand. Use filters above to narrow by form, heat treatment, basis, or test environment.

Verified Unverified Low confidence (<80%) Link to source

Property	Value	Unit	Conditions	Source
Density(ρ)	8.221	kg/m³	22°C

Rows with are inherited from the base material

Verified Unverified Low confidence (<80%) Link to source

Reference data from cited sources. Not verified or certified by MatWorld Inc. Verify against the source before use in design. Terms: engineering data

Regulatory Screening

Environmental

Export Control

Safety & Biocompatibility

Quality & Standards

Industry-Specific

RoHS, REACH, and Prop 65 statuses are validated against official substance lists (ECHA SVHC Candidate List, OEHHA Prop 65, RoHS Annex II). Other regulations are estimated from composition and material classification. All screening is a starting point for due diligence — always verify with your supplier before making compliance decisions.